DP-M Series Volt Meters
Voltage and current in, multi-function digital control meter.
• Two lines; one for current value (red LED), one for setting value (green LED)
• Voltage & current indicator
• Multi-function
• Multiple range scaling
• 5 digit LED display
• Character height of 0.56" for the red and 0.3" for the green LED
• Voltage & current indicator
• Multi-function
• Multiple range scaling
• 5 digit LED display
• Character height of 0.56" for the red and 0.3" for the green LED
See bottom of page for Pricing
Features two lines displaying the current value and setting value simultaneously. Easy-to-use multiple range scaling; either manually or by using the "teach" function setup with a forced zero. It provides sensor-reserved power for use. The use-load function of the cell will be a load-cell list.
| Supply Voltage | AC/DC 90~260V 50/60Hz |
| Consumed Power | Max. 15VA |
| Insulation Impedance | 20M£[ at least (DC500V) between connecters |
| Hi-pot test | AC2000V min between connecters and the case |
| Noise susceptibility | 2KV 5KHz |
| Ambient temperature | 0~+50°C |
| Ambient Humidity | 28~85%RH(No fog) |
| Storage temperature | -20~+65°C |
| Weight | 285g |
| External Dimensions | 96(W)X48(H)X140(L)mm |
| Input signal | AC. DC Voltage current |
| Sampling Timers | 15 preset. at 60Hz, 12.5 preset at 50Hz |
| Maximum display value | -19999~99999 |
| Accuracy | 0.1%FS (DC, Voltage, current) |
| 0.2%FS (AC, Voltage, current) | |
| Display specification | 0.56" red LED, 0.3" Green LED |
| Force to zero | External setup, use, and store function |
| Ratio setup | Decimal point position can be adjusted manually, directly from the "teach" mode panel. |
| Keep function | Record the maximum value by measuring input. When power supply is on, it can be cleared manually or automatically |
| External functions | Hold measured value; clear maximum value; display maximum value and force to zero. |
| Other functions | set startup delay time; compare output; can set the delay time in each section |
| Process average value (move mode or simple mode) | |
| Comparing output has three modes to choose from.(Standard, Zone, level) | |
| Output mode | Relay contact output, transistor output, linear output, communication output. |